How To Display The Current Ip Advertising Configuration; How To Configure The Ip Address Of The Management Interface; Options; Configuring The Ip Address Of The Management Interface: Example - Cisco SCE8000 Configuration Manual

Chapter 5 Configuring the Management Interface and Security

How to Display the Current IP Advertising Configuration

From the SCE# prompt, type show ip advertising and press Enter.
Step 1
Displays the status of IP advertising (enabled or disabled), the configured destination, and the configured
interval

How to Configure the IP Address of the Management Interface

The user must define the IP address of the management interface.
Changing the IP address of the management interface via telnet will result in loss of the telnet connection
Note
and inability to reconnect with the interface.
After changing the IP address, you must reload the SCE platform (See
Note
SCE Platform, page
components of the SCE platform.

Options

The following options are available:
•
•
Step 1 Connect the SCE platform directly to a local console.
Establishes contact with the SCE platform that is not dependent on the configured IP address.
From the SCE(config if)# prompt, type ip address ip-address subnet-mask and press Enter.
Step 2
Configures a new IP address for the management interface
The command might fail if there is a routing table entry that is not part of the new subnet defined by the
new IP address and subnet mask..

Configuring the IP Address of the Management Interface: Example

The following example shows how to set the IP address of the SCE platform to 10.1.1.1 and the subnet
mask to 255.255.0.0.
SCE(config if)#ip address 10.1.1.1 255.255.0.0
OL-16479-01
3-14) so that the change will take effect properly in all internal and external
ip-address — The IP address of the management interface. If both management ports are connected,
so that a backup management link is available, this IP address will be act as a virtual IP address for
the currently active management port, regardless of which physical port is currently active.
subnet mask — subnet mask of the management interface.
Rebooting and Shutting Down the
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
IP Configuration
5-37