About Management Interface And Security - Cisco SCE8000 Configuration Manual

Configuring the Management Interface and
Security
This module describes how to configure the physical management interfaces (ports) as well as the
various management interface applications, such as SNMP, SSH, and TACACS+. It also explains how to
configure users, passwords, IP configuration, clock and time zone, and domain name settings.
•
•
•
•
•
•
•
•
•
•

About Management Interface and Security

The Service Control Module is equipped with an RJ-45 management (MNG) port. This Gigabit Ethernet
port provides access from a remote management console to the SCE platform via a LAN.
Perform the following tasks to configure the management interface and management interface security:
•
•
OL-16479-01
About Management Interface and Security, page 5-1
Configuring the Management Port, page 5-2
How to Enter Management Interface Configuration Mode, page 5-2
Configuring the Management Port Physical Parameters, page 5-2
Configuring the Available Interfaces, page 5-6
Configuring and Managing the SNMP Interface, page 5-25
IP Configuration, page 5-33
Configuring and Managing the SNMP Interface, page 5-25
Configuring Time Clocks and Time Zone, page 5-38
Domain Name Server (DNS) Settings, page 5-44
Configure the management port:
– Physical parameters
Configure management interface security
– Configure the permitted and not-permitted IP addresses
C H A P T E R
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
5
5-1