Configuring Ip Advertising - Cisco SCE8000 Configuration Manual

IP Configuration
•
•
•

Configuring IP Advertising

To configure IP advertising, you must first enable IP advertising. You may then specify a destination
address to which the ping request is to be sent and/or the frequency of the ping requests (interval). If no
destination or interval is explicitly configured, the default values are assumed.
Options
The following options are available in the IP advertising commands:
•
•
How to Enable IP Advertising
From the SCE(config)# prompt, type ip advertising and press Enter.
Step 1
Enables IP advertising.
How to Configure the IP Advertising Destination
From the SCE(config)# prompt, type ip advertising destination destination, and press Enter.
Step 1
Configures the destination for the IP advertising pings.
How to Configure the IP Advertising Interval
From the SCE(config)# prompt, type ip advertising interval interval, and press Enter.
Step 1
Configures the frequency of the IP advertising pings.
Configuring IP Advertising: Example
The following example shows how to configure IP advertising, specifying 10.1.1.1 as the destination and
an interval of 240 seconds.
SCE(config)#ip advertising destination 10.1.1.1
SCE(config)#ip advertising interval 240
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
5-36
show ip advertising
show ip advertising destination
show ip advertising interval
interval — The time interval between pings in seconds.
default interval = 300 seconds
destination — The IP address of the destination for the ping requests
default destination = 127.0.0.1
Chapter 5 Configuring the Management Interface and Security
OL-16479-01