How To Activate The External Bypass; How To Deactivate The External Bypass; How To Set The External Bypass To The Default State - Cisco SCE8000 Configuration Manual
Service control engine
Hide thumbs
Also See for SCE8000:
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages) ,
- Removal and replacement procedures (36 pages)
Table of Contents
Advertisement
Chapter 7
Configuring the Connection
Figure 7-1
How to Activate the External Bypass
From the SCE(config if)# prompt, type external-bypass and press Enter.
Step 1
How to Deactivate the External Bypass
Step 1
From the SCE(config if)# prompt, type no external-bypass and press Enter.
How to Set the External Bypass to the Default State
The default state of the external optical bypass is deactivated.
From the SCE(config if)# prompt, type default external-bypass and press Enter.
Step 1
OL-16479-01
External Optical Bypass Connectivity
Default bypass state (no power)
Non-default bypass state
OPB
3/0/0
3/1/0
3/2/0
3/3/0
SCE8000
OPB
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
External Optical Bypass
7-5
Advertisement
Table of Contents
