How To Display The Current Counters; How To Display All Currently Handled Attacks; How To Display All Existing Force-Filter Settings; How To Display All Existing Don't-Filter Settings - Cisco SCE8000 Configuration Manual
Service control engine
Hide thumbs
Also See for SCE8000:
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages) ,
- Removal and replacement procedures (36 pages)
Table of Contents
Advertisement
Chapter 10
Identifying and Preventing Distributed-Denial-Of-Service Attacks
How to display the current counters
Use this command to display the current counters for the specified attack detector for attack types for a
specified IP address.
Step 1
From the SCE> prompt, type show interface linecard 0 attack-filter query ((single-sided ip
ip-address)|(dual-sided source-IP source-ip-address destination-IP dest-ip-address)) [dest-port
portnumber] current and press Enter.
How to display all currently handled attacks
From the SCE> prompt, type show interface linecard 0 attack-filter current-attacks and press Enter.
Step 1
How to display all existing force-filter settings
From the SCE> prompt, type show interface linecard 0 attack-filter force-filter and press Enter.
Step 1
How to display all existing don't-filter settings
From the SCE> prompt, type show interface linecard 0 attack-filter dont-filter and press Enter.
Step 1
How to display the list of ports selected for subscriber notification
From the SCE> prompt, type show interface linecard 0 attack-filter subscriber-notification ports and
Step 1
press Enter.
OL-16479-01
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
Monitoring Attack Filtering
10-27
Advertisement
Table of Contents
