Cisco SCE8000 Configuration Manual page 180

Monitoring Subscribers
How to display subscribers that are mapped to a specified IP address, or range of IP addresses
Options
The following options are available:
ip-range — IP address (x.x.x.x) or range of IP addresses (x.x.x.x/y) to match
•
From the SCE> prompt, type show interface linecard 0 subscriber mapping IP ip-range and press
Step 1
Enter.
How to display subscribers that are mapped to IP addresses that are included in a given IP address or IP range
Options
The following options are available:
ip-range — IP address (x.x.x.x) or range of IP addresses (x.x.x.x/y) to match
•
From the SCE> prompt, type show interface linecard 0 subscriber mapping included-in IP ip-range
Step 1
and press Enter.
How to display subscribers that are mapped to a specified VLAN ID
Options
The following options are available:
• VLAN-id — VLAN ID to match
From the SCE> prompt, type show interface linecard 0 subscriber mapping VLAN-id VLAN-id and
Step 1
press Enter.
How to display subscribers with no mapping
From the SCE> prompt, type show interface linecard 0 subscriber mapping none and press Enter.
Step 1
How to display the number of subscribers that are mapped to a specified VLAN ID
Options
The following options are available:
• VLAN-id — VLAN ID to match
From the SCE> prompt, type show interface linecard 0 subscriber amount mapping VLAN-id
Step 1
VLAN-id and press Enter.
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
9-16
Chapter 9 Managing Subscribers
OL-16479-01