How To Display Subscribers: By Mapping (Ip Address Or Vlan Id) - Cisco SCE8000 Configuration Manual

Chapter 9 Managing Subscribers
How to display the number of subscribers that are greater than or less than a specified value of a subscriber
property
Options
The following options are available:
•
•
From the SCE> prompt, type show interface linecard 0 subscriber amount property propertyname
Step 1
greater-than|less-than property-val and press Enter.
How to display the number of subscribers that match a specified prefix
Options
The following options are available:
•
From the SCE> prompt, type show interface linecard 0 subscriber amount prefix prefix and press
Step 1
Enter.

How to Display Subscribers: By Mapping (IP Address or VLAN ID)

•
•
•
•
•
•
You can display the subscribers who are mapped to any of the following:
•
•
•
•
You can also display just the number of subscribers with a specified mapping, rather than listing the
actual subscribers.
OL-16479-01
propertyname — name of the subscriber property to match
property-val — value of that subscriber property to match
prefix — subscriber prefix to match
How to display subscribers that are mapped to a specified IP address, or range of IP addresses,
page 9-16
How to display subscribers that are mapped to IP addresses that are included in a given IP address
or IP range, page 9-16
How to display subscribers that are mapped to a specified VLAN ID, page 9-16
How to display subscribers with no mapping, page 9-16
How to display the number of subscribers that are mapped to a specified VLAN ID, page 9-16
How to display the number of subscribers with no mapping, page 9-17
A specified IP address, or range of IP addresses
IP addresses intersecting a given IP address or IP range
A specified VLAN ID
no mapping
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
Monitoring Subscribers
9-15