Aligning The Speed Module - HBM T10F Mounting Instructions

Settings
calibration signal is triggered, the LED shines more
brightly.
Control LED
Fig. 9.4 Power transmission function test
9.4.2

Aligning the speed module

When required, you can test the correct functioning of
the speed measuring system.
1. Remove the cover of the stator housing.
-1
2. Turn the rotor by at least 2 min .
If both the control LEDs come on while you are turning
the rotor, the speed measuring system is properly
aligned and fully operational.
T10F 53
A0608-14.0 HBM: public