Front Bumper Assembly; Front Body Panel/Fender - Arctic Cat 2012 350 Service Manual

Front Bumper Assembly

REMOVING
1. Remove the two front cap screws securing the front
rack to the bumper support tubes; then remove two
cap screws and nuts securing the bumper support
tubes to the frame.
2. Remove the through-bolt and lock nut securing the
bumper to the frame; then remove the bumper.
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean all bumper components with parts-cleaning
solvent.
2. Inspect all welds for cracking or bending.
INSTALLING
1. Place the front bumper assembly into position and
install the through-bolt. Start the lock nut and fin-
ger-tighten only.
2. Install the existing fasteners in the upper support
tubes to frame and the front rack cap screws. Tighten
the lock nut (from step 1) to 20 ft-lb; then tighten the
cap screws securely.

Front Body Panel/Fender

REMOVING
1. Remove the seat and both side panels.
2. Remove the front rack; then disconnect the head-
light/running light connectors located on the frame.
 NOTE: Use a small screwdriver to disengage the tab
connector allowing the connector assembly to be
removed from the frame.
118
3. Remove the cap screws (A); then remove the rein-
stallable rivets (B) and remove the tank cover.
4. Remove the shift knob; then remove the shift mecha-
nism splash shield.
KC224
Manual
Table of Contents
KC223
KC219A
KC220
KC211