Canon Inner Finisher-H1 Service Manual page 49

6. Remove the 2 Screws [1],fixing the Rail.
2x
7. Remove this machine from the host machine.
CAUTION:
Do not slide the Inner Finisher as putting it on the host
machine or bump the edge parts of the rail unit to the
covers of the host machine.
It may cause damage to the host machine.
[1]
[1]
4. Parts Replacement and Cleaning
● Checking after Assembly
1. Install the finisher in the host machine.
2. Turn the host machine on.
3. Open the finisher front cover.
4. Check that the stapler unit [1] is at the staple
cartridge replacement position as shown in the
figure.If it is, close the finisher front cover to
complete the check procedure.
5. If the staple unit is not at the staple cartridge
replacement position, perform the following
procedure.
The stapler unit's roller may be riding on the base plate.
so, slightly lift the stapler unit [1],and rotate the roller
toward you to correct the position.
[1]
6. Close the finisher front cover.Open the finisher front
cover again, and check that the staple unit is at the
staple cartridge replacement position.
7. Close the finisher front cover.
43
[1]
[1]