Canon Inner Finisher-H1 Service Manual page 31

■ Alignment Operation in Staple Mode
1. After the delivery sensor (PS1) detects the trailing edge of the paper, the front and rear alignment plates move to the wait
positions.Explanation for 2-point stapling will be omitted because it is the same as the center alignment operation in Non-
sort mode.
• Front 1-point stapling (front alignment plate position: paper width position (148.5 mm), rear alignment plate position:
paper width + 5 mm)
• Rear 1-point stapling (front alignment plate position: paper width + 5 mm, rear alignment plate position: center + 148.5
mm)
2. Move the front and rear alignment plates to align the paper.
■ Alignment Operation in Staple-free Staple Mode
Explanation for staple-free staple mode will be omitted because it is the same as the rear alignment operation in rear 1-point
stapling mode.
End of Paper
+5 mm
Middle of Feeding Path
148.5 mm
148.5 mm
Middle of Feeding Path
End of Paper
+5 mm
Rear Alignment Position
5mm
Middle of Feeding Path
5mm
Front Alignment Position
Rear Alignment Plate
Front Alignment Plate
Rear Alignment Plate
Front Alignment Plate
25
2. Technical Explanation