Installation; Connecting To The Pc Via Lan; Connecting The Unit To The Power Supply; Installing The Unit - Sirona CEREC MC XL Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
61 46 885 D 3439
D 3439.201.02.19.02 12.2014
5.4.7

Installation

5.4.7.1

Connecting to the PC via LAN

An Ethernet connection is located to the rear of the unit, which can be
used to connect the PC to the grinding unit. Use a network cable to do this
(LAN connection).
Using a network cable
Connect the PC to the LAN connection of the unit.
If problems arise when connecting via a network cable, please read the
separate instructions "Operating the MC XL via LAN".
5.4.7.2

Connecting the unit to the power supply

NOTICE
Grounded power outlet
The unit must be connected to a grounded power outlet.
➢ Connect the unit to the power supply using the supplied power cable.
5.4.7.3

Installing the unit

You must connect the unit to the PC before putting it into operation. This
Introduction worldwide
is described in the section entitled "Connecting to the PC via LAN" [ → 19]
or "Connecting to the PC via WLAN (option)" [ → 21].
Searching for unit automatically
Searching for a title automatically
The unit is connected to the PC via a LAN cable or via WLAN.
Prerequisite worldwide
"Configuration"
1. Click the
Searching for a unit automatically, MC XL/MC/MC X
2. Click on the
3. Click on the
 All units connected to the PC are recognized. In the case of new
units, you will be prompted to enter a name.
4. Enter a name for the new unit.
Searching for a title manually
button in the system menu.
"Devices"
button.
"Scan for New Devices" button.
5 Installation and startup
5.4 Commissioning
19