Table of Contents
Advertisement
The GPO parameter tab showing the parameters for one of the four General Purpose Output
ports is shown in
X-Ref Target - Figure 4-5
•
Use GPO - Enable the General Purpose Output port.
•
Number of Bits - Set the number of bits of the General Purpose Output port.
•
Initial Value of GPO - Set the initial value of the General Purpose Output port. The
right most bit in the value is assigned to bit 0 of the port, the next right most to bit 1,
and so on.
MicroBlaze Micro Controller System v1.3
PG048 December 18, 2012
Figure
4-5.
Figure 4-5: GPO Parameter Tab
www.xilinx.com
Chapter 4: Customizing and Generating the Core
19
Advertisement
Table of Contents
