Table of Contents
Advertisement
BIT SWITCHES
4.2.3 PRINTER SWITCHES
Printer Switch 00
No
FUNCTION
0
Page separation mark
0: Disabled
1: Enabled
1
Repetition of data when the
received page is longer than
the printer paper
0: Disabled
1: Enabled
2-7 Not used
Printer Switch 01
No
FUNCTION
0
Reset the fusing unit failure
0: Off
1: On (Clear)
1-7 Not used
Printer Switch 02 - Not used (do not change any of these settings)
COMMENTS
0: No marks printed.
1: If an incoming fax requires two sheets to print,
the machine prints an "x" inside a small box at
the bottom right hand corner of the first sheet.
Then, it prints a "2" inside a small box at the top
right hand corner of the second sheet. This
helps the user identify pages that have been
split up.
0: The next page continues from where the
previous page left off.
1: The final few mm of the previous page are
printed at the top of the next page.
See section 2.2.12 for details.
Do not change the settings.
COMMENTS
When a fusing error occurs, set this bit to 1 after
fixing the problem. The machine then resets the
fusing error. Switch the machine off/on and this
bit will reset itself to 0.
Do not change the settings.
4-22
30 November, 1999
Advertisement
Table of Contents
