Table of Contents
Advertisement
30 November, 1999
4.4.2 PARAMETERS
The initial settings of the following parameters are all FF(H) - all the parameters are
disabled.
Byte 0
ITU-T T1 time
If the connection time to a particular terminal is longer than the NCU parameter setting,
adjust this byte. The T1 time is the value stored in this byte (in hex code), multiplied by
1 second.
Range:1 to 127 s (01h to 7Fh)
00h or FFh - The local NCU parameter factory setting is used.
Do not program a value between 80h and FEh.
Byte 1
0
TX level
to
Bit 3
2
3
0
0
0
0
1
1
4
TX level setting
0: Enabled
1: Disabled (bits 0 to 4 must all be at 1
to disable)
5
Cable equalizer
Bit 6
Bit 5
6
0
0
0
1
1
0
1
1
7
Cable equalizer setting
0: Enabled
1: Disabled (bits 5 to 7 must all be at 1
to disable)
FUNCTION AND COMMENTS
FUNCTION
1
0
Setting (dBm)
0
0
0
0
1
-1
:
1
1
-15
Setting
None
Low
Medium
High
DEDICATED TRANSMISSION PARAMETERS
COMMENTS
If communication with a particular
remote terminal often contains
errors, the signal level may be
inappropriate. Adjust the TX level for
communications with that terminal
until the results are better.
0: When enabling the TX level
setting, change this bit to 0, then
change the settings of bits 0 through
3 above.
1: When disabling the TX level
setting, change all of the bits 0
through 4 to 1.
Use a higher setting if there is signal
loss at higher frequencies because
of the length of wire between the
modem and the telephone exchange
when calling the number stored in
this Quick/Speed Dial.
Also, try using the cable equalizer if
one or more of the following
symptoms occurs.
•
Communication error with error
codes such as 0-20, 0-23, etc.
•
Modem rate fallback occurs
frequently.
0: When enabling the cable
equalizer setting, change this bit to
0, then change the settings of bits 5
and 6 above.
1: When disabling the cable
equalizer setting, change all of the
bits 5, 6 and 7 to 1.
4-47
Advertisement
Table of Contents
