Table of Contents
Advertisement
30 November, 1999
4.2 BIT SWITCHES
ø
WARNING
Do not adjust bit switches described as "Not used", as this may cause the
machine to malfunction or to operate in a manner that is unacceptable under local
regulations. Such bits are only for use in other areas, such as Japan.
NOTE: This manual does not list default settings for bit switches. Refer to the
System Parameter List.
4.2.1 SYSTEM SWITCHES
System Switch 00
No
FUNCTION
RAM Reset
Bit 1
Bit 0 Reset Level
0
0
0
1
1
0
1
1
0
1
Reset Level 3: Erases all image data files
stored in the SAF memory and
communication files (e.g. substitute RX
No reset
files). This is the recommended setting
Reset Level 2
when the SAF requires clearing.
Reset Level 3
Reset Level 2: This level erases the
Not used
following items in addition to those erased
by Reset Level 3: own telephone number,
bit switches (excluding country code),
RTI/TTI/CSI, report data, programmed
telephone numbers (Quick/Speed/Groups,
service station, etc.), NCU parameters, and
personal codes.
After erasing, the machine automatically
changes these two bits back to 0.
Important:
When RAM reset level 2 is done, the
machine refers to the bit switch country
code (System bit switch 0F: functional
settings) and automatically changes the
NCU country code (NCU parameter: RAM
807F00) to the same code.
No reset: Normal operation
Cross-reference
RAM Reset Level 1 (Factory reset):
Change the RAM address data from
800005(H) to FF(H), then turn the machine
off and on. In addition to those items erased
by Reset Level 2, the clock, country code
(the default country code is for the U.S.),
scan margin settings and print registration
settings are erased.
4-13
BIT SWITCHES
COMMENTS
Advertisement
Table of Contents
