Sram Data Download (Function 12) - Ricoh FAX2000L Service Manual

30 November, 1999
ê 4
6.
If the software uploads successfully, the
display shows "OK".
If the software upload fails, the display shows
"NG".
'6
7. Finish :
8. Turn off the machine and disconnect the tool. Then turn the machine back on
again.

4.1.24 SRAM DATA DOWNLOAD (FUNCTION 12)

This function copies all the data stored in the SRAM on an external FCU to the
FCU inside the machine. Use this after replacing a damaged FCU to save any
previously programmed settings in the damaged FCU.
1. Turn off the machine.
2. Connect the Flash/SRAM Copy Tool and the damaged FCU.
NOTE: The setting of the switch on the tool will not affect the result of this
procedure.
3. Turn on the machine.
'6
ç ì ä ä å
4.
then immediately press
ì ë :
5.
á
è
6.
4
7.
If the SRAM data downloads successfully, the display shows "OK".
If the SRAM download fails, the display shows
"CANNOT PROGRAM".
'6
8. Finish :
9. Turn off the machine and disconnect the tool. Then turn the machine back on.
:
4-11
SERVICE LEVEL FUNCTIONS
OK!!
COPY MACH -> FLROM
NG!!
COPY MACH -> FLROM
FUNCTION KPAD/NEXT>
SERVICE FUNCTIONS
0-SRAM 1-SAF
2-SAFCARD 3-M->R
OK!!
COPY MACH <- SRAM
COPYING
CANNOT PROGRAM