Printer Switches - Ricoh FAX2900L Service Manual

BIT SWITCHES

4.2.3 PRINTER SWITCHES

Printer Switch 00
No FUNCTION
0 Page separation mark
0: Disabled
1: Enabled
1 Repetition of data when the
received page is longer than
the printer paper
0: Disabled
1: Enabled
2-7 Not used
Printer Switch 01
No FUNCTION
0 Reset the fusing unit failure
0: Off
1: On (Clear)
1-7 Not used
Printer Switch 02
No FUNCTION
0 Paper Feed Priority
0: Paper feed unit >> Multi-
purpose feeder >> Standard
cassette
1: Paper feed unit >> Standard
cassette >> Multi-purpose
feeder
2-7 Not used
COMMENTS
0: No marks printed.
1: If an incoming fax requires two sheets to print,
the machine prints an "x" inside a small box at
the bottom right hand corner of the first sheet.
Then, it prints a "2" inside a small box at the top
right hand corner of the second sheet. This
helps the user identify pages that have been
split up.
0: The next page continues from where the
previous page left off.
1: The final few mm of the previous page are
printed at the top of the next page.
See section 2.2.12 for details.
Do not change the settings.
COMMENTS
When a fusing error occurs, set this bit to 1 after
fixing the problem. The machine then resets the
fusing error. Switch the machine off/on and this
bit will reset itself to 0.
Do not change the settings.
COMMENTS
This bit determines which set of priorities the
machine uses for feeding the paper when all the
cassettes contain the same paper size.
Do not change these settings.
4-26
21 May, 1999