Table of Contents
Advertisement
BIT SWITCHES
3.2.3 PRINTER SWITCHES
Printer Switch 00
No
FUNCTION
0
Page separation mark
0: Disabled
1: Enabled
1
Repetition of data when the
received page is longer than
the printer paper
0: Disabled
1: Enabled
2
Prints the date and time on
received fax messages
0: Disabled
1: Enabled
3-7
Not used
Printer Switch 01
No
FUNCTION
0-2
Not used
3-4
Maximum print width used in
the setup protocol
Bit 4 3
0
0
0
1
1
0
1
1
5-6
Not used
7
Received message width
restriction in the protocol signal
to the sender
0: Disabled
1: Enabled
Setting
Not used
A3
B4
A4
COMMENTS
0: No marks are printed.
1: If a received page has to be printed out on two
sheets, an asterisk inside square brackets is
printed at the bottom right hand corner of the first
sheet, and a "2" inside a small box is printed at
the top right hand corner of the second sheet.
This helps the user to identify pages that have
been split.
0: The next page continues from where the previous
page left off.
1: The final few mm of the previous page are
repeated at the top of the next page. The amount
of repeated data depends on printer switch 04,
bits 5 and 6.
This switch is only effective when user parameter 02
- bit 2 (printing the received date and time on
received fax messages) is enabled.
1: The machine prints the received and printed date
and time at the bottom of each received page.
Do not change the settings.
COMMENTS
Do not change the settings.
These bits are only effective when bit 7 of printer
switch 01 is "1".
Do not change the settings.
0: The machine informs the transmitting machine of
the print width depending on the paper size
available from the paper feed stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the
setup protocol (NSF/DIS).
1: The machine informs the transmitting machine of
the fixed paper width which is specified by bits 3
and 4 above.
3-26
21 December, 2001
SP No. 1-103-001
SP No. 1-103-002
Advertisement
Table of Contents
