Table of Contents
Advertisement
30 November, 1999
G3 Switch 0A
FUNCTION
0
Maximum allowable carrier
drop during image data
1
reception
Bit 1
Bit 0
0
0
0
1
1
0
1
1
2-3 Not used
4
Maximum allowable frame
interval during image data
reception.
0: 5 s
1: 13 s
5
Not used
6
Reconstruction time for the
first line in receive mode
0: 6 s
1: 12 s
7
Not used
G3 Switch 0B
FUNCTION
0
Protocol requirements: Europe
0: Disabled 1: Enabled
1
Protocol requirements: Spain
0: Disabled 1: Enabled
2
Protocol requirements:
Germany
0: Disabled 1: Enabled
3
Protocol requirements: France
0: Disabled 1: Enabled
4
PTT requirements: Germany
0: Disabled 1: Enabled
5-7 Not used
These bits set the acceptable modem carrier
drop time.
Try using a longer setting if error code 0-22 is
Value (ms)
frequent.
200
400
800
Not used
Do not change these settings.
This bit determines the maximum interval
between each EOL signal (end-of-line) or
between each ECM frame from the other end.
Try using a longer setting if error code 0-21 is
frequent.
Do not change this setting.
When a computer controls the sending terminal,
there may be a delay in receiving page data
after the local machine accepts set-up data and
sends CFR. If this occurs, set this bit to 1 to give
the sending machine more time to send data.
Refer to error code 0-20.
Do not change this setting.
Program these bit switches manually to match
local requirements.
Do not change these settings.
4-35
BIT SWITCHES
COMMENTS
COMMENTS
Advertisement
Table of Contents
