Calculate[1|2]:Limit:lower[:Data] <Mumeric_Value; Measurement Units - HP E4418B Programming Manual

CALCulate[1|2]:LIMit:LOWer[:DATA] <mumeric_value>
This command is used to enter a value for the lower test limit for the
specified window used in the CALCulate[1|2]:LIMit:FAIL? test. The
units used are dependent on the current setting of UNIT:POWer and
CALCulate:RELative:STATe as shown in Table 3-1. When the
measured value is less than the value specified in
CALCulate[1|2]:LIMit:LOWer[:DATA],
CALCulate[1|2]:LIMit:FAIL? reports a fail. When the measured
value is greater than or equal to the limit, a fail is not reported.
Single Channel
Ratio
Difference
Syntax
CALC
1
2
HP E4418B/E4419B Programming Guide
Table 3-1: Measurement Units
Measurement
Mode
:LIM :LOW
CALCulate[1|2]:LIMit:LOWer[:DATA] <mumeric_value>
CALC:REL:STAT OFF
Linear Log
Watt dBm
% dB
Watt dBm
Space
:DATA
?
CALCulate Subsystem
CALC:REL:STAT ON
Linear Log
% dB
% dB
% dB
numeric_value
DEF
MIN
MAX
Space
MIN
MAX
3-15