CALCulate[1|2]:LIMit:FCOunt?
This query is used to return the total number of limit failures for the
specified window.
If the appropriate STATe commands are set to ON, each time a
measurement is initiated on the specified window and the measurement
result is outside the limits, the counter is incremented by one.
If the measured value is equal to a limit, this is a limit pass.
The counter is reset to zero by any of the following commands:
When CALCulate[1|2]:LIMit:CLEar:AUTO is set to ON, the counter is
set to zero each time a measurement:
When CALCulate[1|2]:LIMit:CLEar:AUTO is set to ONCE, the counter
is set to zero the first time a measurement:
The maximum number of errors is 2
detected the counter returns to zero.
HP E4418B/E4419B Programming Guide
•
*RST
•
CALCulate[1|2]:LIMit:CLEar:IMMediate
•
CALCulate[1|2]:LIMit:CLEar:AUTO ON
•
is measured using MEASure?
•
is read using READ?
•
is initiated using:
INITiate[:IMMediate] or,
INITiate:CONTinuous ON.
•
is measured using MEASure?
•
is read using READ?
•
is initiated using:
INITiate[:IMMediate] or,
INITiate:CONTinuous ON.
CALCulate Subsystem
CALCulate[1|2]:LIMit:FCOunt?
16
16
-1. If more than 2
-1 errors are
3-13