Measure[1|2][:Scalar][:Power:ac]:Difference:relative? [<Expected_Value>[,<Resolution>[,<Source List>]]] - HP E4418B Programming Manual

MEASurement Instructions
MEASure[1|2][:SCALar][:POWer:AC]:DIFFerence:RELative?
[<expected_value>[,<resolution>[,<source list>]]]
MEASure[1|2][:SCALar][:POWer:AC]:DIFFerence:RELative?
[<expected_value>[,<resolution>[,<source list>]]]
This command is only relevant for the HP E4419B power meter.
This command sets the specified window's measurement function to
difference mode with relative mode on, aborts, configures then initiates
both channel A and B, calculates the difference measurement result and
places the result on the bus. The result is a ratio based measurement and
is expressed in the units defined by UNIT[1|2]:POWer:RATio. The
relative value used is that set by the
CALCulate:RELative:MAGNitude:AUTO command.
Syntax
MEAS 1
2
Parameters
Refer to "The Optional Parameters", on page 2-3 for additional details on
the parameters in this command.
2-56
:POW
:SCAL
expected_value
Space
DEF
Item Description/Default
expected_value The power meter ignores the
(for the
numeric value entered in this
expected
parameter. Any value entered is
power level)
treated like DEF.
resolution A numeric value for the resolution.
If unspecified the current
resolution setting is used.
:REL
:AC :DIFF
,
resolution
DEF
HP E4418B/E4419B Programming Guide
?
,
source list
Range of Values
sensor dependent
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF