SYSTem Subsystem
SYStem:COMMunicate:Serial Node
SYStem:COMMunicate:Serial Node
This node controls the settings for the RS232/RS422 serial interface. The
commands allow you to:
The commands accociated with this node are:
SYSTem:COMMunicate:SERial:CONTrol:DTR
SYSTem:COMMunicate:SERial:CONTrol:RTS
SYSTem:COMMunicate:SERial:[:RECeive]:BAUD
SYSTem:COMMunicate:SERial:[:RECeive]:BITs
SYSTem:COMMunicate:SERial:[:RECeive]:PACE
SYSTem:COMMunicate:SERial:[:RECeive]:PARity:[TYPE]
SYSTem:COMMunicate:SERial:[:RECeive]:SBITs
SYSTem:COMMunicate:SERial:TRANsmit:AUTO?
SYSTem:COMMunicate:SERial:TRANsmit:BAUD
SYSTem:COMMunicate:SERial:TRANsmit:BITs
SYSTem:COMMunicate:SERial:TRANsmit:ECHO
SYSTem:COMMunicate:SERial:TRANsmit:PARity:[TYPE]
SYSTem:COMMunicate:SERial:TRANsmit:SBITs
11-4
•
Set the function of the DTR and RTS signal lines
•
Set the transmit/receive baud rate
•
Set the transmit/receive word length
•
Set the transmit/receive parity type
•
Set the transmit/receive stop bits
•
Enable /disable XON/XOFF software handshaking
HP E4418B/E4419B Programming Guide