Hp E4418B/E4419B Programming Guide - HP E4418B Programming Manual

Power Meter Remote Operation
Configuring the Remote Interface
Command
1
SP
2
SPD 20|40
*SRE
*SRE?
ST
*STB?
SYST:LANG SCPI
4
TK?
TR0
TR1
TR2
TR3
5
*TST?
1
UP
ZE
@1
@2
%
1. This command is accepted but has no active function.
2. This command is not an original HP 437B command. However, it can be used to
set the measurement speed to 20 or 40 readings/sec in HP 437B mode. See
SENSE:SPEED for more details.
3. This command is not an original HP 437B command. However, it can be used to
terminate the HP 437B language and select the SCPI language. Note that it is
recommended that the instrument is Preset following a language switch.
4. This command is not an original HP 437B command. However, it can be used to
allow the last measurement result to be transmitted. This is equivalent to
sending the power meter talk address in HP-IB mode to fetch the last reading
(provided no query is pending).
5. Always returns 0000 in HP 437B language.
1-8
Description
Special
20 or 40 readings/sec
Set the service request mask
Service request mask query
Store (save) power meter configuration
Read status byte
3
Selects SCPI language
Last measurement result transmitted
Trigger hold
Trigger immediate
Trigger with delay
Trigger free run
Self test query
Up arrow key
Zero
Prefix for status mask
Learn mode prefix
Percent

HP E4418B/E4419B Programming Guide