Installing The Starter Clutch; Installing The Generator - Yamaha V Star 950 Service Manual

▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install the starter clutch gear "1" onto the
generator rotor "2" and hold the generator
rotor.
b. When turning the starter clutch gear clock-
wise "A", the starter clutch and the starter
clutch gear should engage, otherwise the
starter clutch is faulty and must be
replaced.
c. When turning the starter clutch gear coun-
terclockwise "B", it should turn freely, other-
wise the starter clutch is faulty and must be
replaced.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS24600

INSTALLING THE STARTER CLUTCH

1. Install:
• Starter clutch
• Starter clutch bolts
Starter clutch bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
TIP
While holding the generator rotor "1" with the
sheave holder "2", tighten the starter clutch
bolts.
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
GENERATOR AND STARTER CLUTCH
EAS24500

INSTALLING THE GENERATOR

1. Install:
• Generator rotor
• Washer
• Generator rotor bolt
TIP
• Clean the tapered portion of the crankshaft
and the generator rotor hub.
• When installing the generator rotor, make
sure the woodruff key is properly seated in
the keyway of the crankshaft.
• Lubricate the generator rotor bolt threads
and washer mating surfaces with engine oil.
2. Tighten:
• Generator rotor bolt "1"
TIP
While holding the generator rotor "2" with the
sheave holder "3", tighten the generator rotor
bolt.
3. Apply:
• Sealant
(onto the crankshaft position sensor lead
grommet)
5-42
Generator rotor bolt
90 Nm (9.0 m·kgf, 65 ft·lbf)
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)