Yamaha V Star 950 Service Manual page 77

1. ISC (idle speed control) lead
2. Clamp
3. Engine temperature sensor lead
4. ISC (idle speed control) coupler
5. Fuel sender coupler (natural)
6. Fuel pump coupler (black)
7. Side cover (cylinder head)
8. Rear cylinder ignition coil
9. Plastic band
10.Wire harness
11.Front cylinder ignition coil
A. These can be crossed.
B. Install with the opening facing front.
C. To the ignition coil
D. Make sure that a nail can be hooked and
insert until firmly fixed.
E. Install with the opening facing out.
F. Fuel pump lead, fuel sender lead (order
insignificant)
G. Route the fuel pump lead and fuel sender
lead above the spark plug lead.
H. When clamping the branch section of the
engine temperature sensor lead, put it
inside of the clamp.
I. To the fuel tank
J. Spark plug and wire harness
K. Install with the opening facing back.
L. To the rear cylinder
M. Route the ISC (Idle Speed Control) lead
inside of the spark plug lead.
N. To the front cylinder
O. To the wire harness
P. To the ISC (idle speed control) valve
Q. Install with the opening facing up.
R. ISC (Idle Speed Control) lead and wire har-
ness branch lead/sub lead (order insignifi-
cant)
S. Flap can be in any position.
T. "5S7" sealing side
U. Black connector with white tape
V. Face the lock outside and cut off the
excess end.
W. White connector with white tape
X. White connector
Y. Black connector
Z. Install the spark plug lead's long side to the
front.
2-56
CABLE ROUTING