Yamaha V Star 950 Service Manual page 57

1. Clamp
2. Front brake master cylinder
3. Clutch cable guide
4. Clutch cable
5. Throttle cable (pull side)
6. Throttle cable (return side)
7. Rear brake light switch coupler
8. Starter motor lead
9. Rectifier/regulator lead
10.Rectifier/regulator
11.Corrugate tube
12.Rear brake light switch lead
13.Front brake hose
A. Install the clamp by adjusting to the front
brake hose union bolt position.
B. Clamp the handlebar switch lead. Face the
clamp opening to the back of the vehicle.
C. Insert the rear brake light switch coupler
into the rectifier/regulator bracket com-
pletely.
D. Clamp the starter motor lead, horn lead
and rear brake light switch lead. Opening
can face any direction.
E. The lower end of the mark (gray) on the
starter motor lead should be above the
lower end of the clamp.
F. Clamp the AC magneto lead and rectifier/
regulator lead. Face the ends of the hose
clamp up.
G. Clamp the horn lead and rear brake light
switch lead at the edge of the corrugate
tube. Face the ends of the hose clamp
down.
H. Clamp the horn lead. Face the opening to
the front.
I. Make sure the front brake hose positioned
within 25° as shown in the illustration.
J. 10–20 mm (0.39–0.79 in)
2-36
CABLE ROUTING