Removing The Front Fork Legs; Disassembling The Front Fork Legs - Yamaha V Star 950 Service Manual

EAS22960

REMOVING THE FRONT FORK LEGS

The following procedure applies to both of the
front fork legs.
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there
is no danger of it falling over.
TIP
Place the vehicle on a suitable stand so that
the front wheel is elevated.
2. Loosen:
• Lower bracket pinch bolts
EWA3D81004
WARNING
Before loosening the lower bracket pinch
bolts, support the front fork leg.
EAS22980

DISASSEMBLING THE FRONT FORK LEGS

The following procedure applies to both of the
front fork legs.
1. Drain:
• Fork oil
TIP
Stroke the outer tube several times while drain-
ing the fork oil.
2. Remove:
• Dust seal "1"
• Oil seal clip "2"
(with a flathead screwdriver)
ECA14180
Do not scratch the inner tube.
3. Remove:
• Damper rod bolt "1"
• Copper washer
TIP
While holding the damper rod with the damper
rod holder "2" and T-handle "3", loosen the
damper rod bolt.
Damper rod holder
90890-01460
T-handle
90890-01326
T-handle 3/8" drive 60 cm long
YM-01326
4. Remove:
• Inner tube
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Hold the front fork leg horizontally.
b. Securely clamp the brake caliper bracket in
a vise with soft jaws.
c. Separate the inner tube from the outer tube
by pulling the inner tube forcefully but care-
fully.
ECA14190
• Excessive force will damage the oil seal
and bushing. A damaged oil seal or bush-
ing must be replaced.
• Avoid bottoming the inner tube into the
outer tube during the above procedure, as
the oil flow stopper will be damaged.
4-51
FRONT FORK