Yamaha V Star 950 Service Manual page 71

1. Intake air pressure sensor
2. Clamp
3. Crankcase breather hose
4. Clutch cable
5. Meter lead
6. Plastic band
7. Spark plug lead
8. Starter motor lead (black)
9. Battery lead (red)
10.Relay unit
11.Wire lead
12.Lean angle sensor
13.Lean angle sensor lead
14.Relay unit lead
A. Clamp the intake air pressure sensor lead
with the bracket. Clamp by aligning to the
white paint mark on the lead. Face the lock
to the back and cut off the excess end.
B. Install with the opening facing up.
C. Clamp the crankcase breather hose and
high tension code.
D. Make sure to insert the wire harness clamp
to the frame hole.
E. To tail/brake light assembly
F. Clamp the wire harness, meter lead and
battery negative lead.
Face the end to the front.
G. Make sure that a nail can be hooked in the
seat lock bracket hole and insert until firmly
fixed.
H. Make sure that a nail can be hooked in the
frame hole and insert until firmly fixed.
I. Route the ISC (Idle Speed Control) valve
sub lead in front of the crankcase breather
hose.
J. Clamp the spark plug lead to the frame.
Face the lock and the end to inside.
K. Route above the wire lead.
L. To the wire harness
2-50
CABLE ROUTING