Removing The Lower Bracket; Checking The Steering Head; Installing The Steering Head - Yamaha V Star 950 Service Manual

EAS23110

REMOVING THE LOWER BRACKET

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there
is no danger of it falling over.
2. Remove:
• Upper ring nut
• Rubber washer
• Lower ring nut "1"
• Lower bracket
EWA13730
WARNING
Securely support the lower bracket so that
there is no danger of it falling.
TIP
Remove the lower ring nut with the steering nut
wrench "2".
Steering nut wrench
90890-01403
Exhaust flange nut wrench
YU-A9472
1
EAS23120

CHECKING THE STEERING HEAD

1. Wash:
• Bearings
• Bearing races
Recommended cleaning solvent
Kerosene
2. Check:
• Bearings
• Bearing races
Damage/pitting → Replace.
3. Replace:
• Bearings
• Bearing races
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the bearing races from the steer-
ing head pipe with a long rod "1" and ham-
mer.
b. Remove the bearing race from the lower
bracket with a floor chisel "2" and hammer.
c. Install a new dust seal and new bearing
races.
ECA14270
If the bearing race is not installed properly,
the steering head pipe could be damaged.
TIP
• Always replace the bearings and bearing
races as a set.
• Whenever the steering head is disassem-
bled, replace the dust seal.
2
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4. Check:
• Upper bracket
• Lower bracket
EAS23140

INSTALLING THE STEERING HEAD

1. Lubricate:
• Upper bearing
• Lower bearing
• Bearing races
4-58
STEERING HEAD
(along with the steering stem)
Bends/cracks/damage → Replace.