Installing The Clutch - Yamaha V Star 950 Service Manual

2. Bend lock washer tab along a flat side of
the nut.
EAS25240

INSTALLING THE CLUTCH

1. Install:
• Oil pump drive sprocket "1"
• Oil pump drive chain "2"
TIP
Install the oil pump drive sprocket with its pro-
jections "a" facing outward.
2. Install:
• Clutch housing "1"
TIP
• Fit the projections "a" on the oil pump drive
sprocket into the grooves "b" in the clutch
housing.
• Lubricate the clutch housing bearing with
engine oil.
• Make sure that the primary driven gear teeth
and primary drive gear teeth mesh correctly.
• After installing the clutch housing, make sure
that the primary drive gear "2" and clutch
housing primary driven gear "3" are aligned
as shown in the illustration.
3. Install:
• Clutch boss "1"
• Washer
• Conical spring washer "2"
• Clutch boss nut "3"
Clutch boss nut
125 Nm (12.5 m·kgf, 90 ft·lbf)
TIP
• Lubricate the clutch boss nut threads and
conical spring washer mating surfaces with
engine oil.
• Install the conical spring washer with the
"OUT" mark "a" facing out.
• While holding the clutch boss with the univer-
sal clutch holder "4", tighten the clutch boss
nut.
• Stake the clutch boss nut "3" at cutouts "b" in
the main axle.
Universal clutch holder
90890-04086
YM-91042
5-51
CLUTCH