Installing The Intake Manifold Assembly - Yamaha V Star 950 Service Manual

Digital circuit tester
90890-03174
Model 88 Multimeter with
tachometer
YU-A1927
c. Turn the main switch to "ON".
d. Measure the throttle position sensor output
voltage.
e. Adjust the throttle position sensor angle so
that the output voltage is within the speci-
fied range.
Output voltage (at idle)
0.63–0.73 V
f. After adjusting the throttle position sensor
angle, tighten the throttle position sensor
screws "3".
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS5S71017
INSTALLING THE INTAKE MANIFOLD
ASSEMBLY
1. Install:
• Intake manifold assembly
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install the front cylinder intake manifold
joint "1" to the front cylinder head.
Front cylinder intake manifold
joint bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Install the front cylinder intake manifold joint
with its projection "a" facing up as shown in the
illustration.
THROTTLE BODIES
b. Install the rear cylinder intake manifold joint
"2" to the intake manifold assembly.
TIP
Make sure that the projection "b" on the rear
cylinder intake manifold joint contacts the pro-
jection "c" on the intake manifold assembly.
c. Install the intake manifold assembly.
Rear cylinder intake manifold
joint bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Lubricate the rear cylinder intake manifold joint
and rear cylinder head mating surfaces with
engine oil.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6-12