Yamaha V Star 950 Service Manual page 75

1. Tail/brake light wire harness
2. Tail/brake light wire harness (from taillight)
3. Tail/brake light assembly
4. Rear turn signal light lead
5. Rear turn signal light bracket cover
6. Grommet
7. License plate light coupler
8. Rear right turn signal light coupler
9. Rear left turn signal light coupler
10.Clamp coupler
11.Mudguard (front)
12.Tail/brake light wire harness (from rear turn
signal)
13.License plate light lead
14.Rear fender
A. Route the tail/brake light wire harness
through each clamp. Make sure that no
leads come out of the clamp after bending
it.
B. Make sure to hang the tail/brake light wire
harness on the mudguard's hook.
C. Route the tail/brake light wire harness (rear
turn signal lead, license plate light lead)
through each clamp. Make sure that no
leads come out of the clamp after bending
it.
D. The slit can face any direction.
E. Silicon fluid or soapsuds can be applied
when installing.
F. Route the license plate light lead above the
clamp coupler.
G. Route the rear left turn signal light lead
under the clamp coupler.
H. Route the rear right turn signal light lead
next to the clamp coupler.
I. Fit the clamp coupler's projection inside the
rear turn signal light bracket cover.
J. Install by facing the dent side to the front.
K. Install the grommet on the Taillight lead to
the rear fender hole. Silicon fluid or soap-
suds can be applied when installing.
2-54
CABLE ROUTING