Removing The Fan Bracket - Lenovo System x3650 M4 Installation And Service Manual

Machine type: 7915

Hide thumbs Also See for System x3650 M4:

Table of Contents

Turn the DIMM so that the alignment slot align correctly with the alignment tab.

Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of

the DIMM connector (see "System-board optional-device connectors" on page 32 for the locations

of the DIMM connectors).

Firmly press the DIMM straight down into the connector by applying pressure on both ends of the

DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly

seated in the connector.

Note: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly

inserted; open the retaining clips, remove the DIMM, and then reinsert it.

Step 10. Reconnect the power cords and any cables that you removed.

Step 11. Replace the air baffle (see "Replacing the air baffle" on page 242).

Note: Close all the retaining clips even for slots without DIMMs installed before replacing the

Step 12. Replace the cover (see "Replacing the cover" on page 240).

Step 13. Turn on the peripheral devices and the server.

Removing the fan bracket

Use this information to remove the fan bracket.

To replace some components or to create working room, you might have to remove the fan-bracket assembly.

Note: To remove or install a fan, it is not necessary to remove the fan bracket. See "Removing a hot-swap

fan" on page 311 and "Replacing a hot-swap fan" on page 312.

To remove the fan bracket, complete the following steps:

Removing and replacing components