Removing An Adapter - Lenovo System x3650 M4 Installation And Service Manual

Figure 192. PCI riser-card assembly installation
b. PCI connector 2: Carefully align the bottom edge (the contact edge) of the riser-card assembly
with the riser-card connector on the system board.
Step 6. Press down on the assembly. Make sure that the riser-card assembly is fully seated in the
riser-card connector on the system board.
Step 7. Replace the cover (see "Replacing the cover" on page 240).
Step 8. Slide the server into the rack.
Step 9. Reconnect the power cords and any cables that you removed.
Step 10. Turn on the peripheral devices and the server.

Removing an adapter

Use this information to remove an adapter.
This topic describes removing an adapter from a PCI expansion slot in a PCI riser-card assembly. These
instructions apply to PCI adapters such as video graphic adapters and network adapters.
The following illustration shows the locations of the adapter expansion slots from the rear of the server.
280
Lenovo System x3650 M4 Installation and Service Guide
PCI riser-card
assembly 2
PCI riser-card
assembly 1