Installing A Usb Embedded Hypervisor Flash Device - Lenovo System x3650 M4 Installation And Service Manual

Machine type: 7915

Hide thumbs Also See for System x3650 M4:

Table of Contents

• Tape drive power cable to the system board

Figure 118. Cable connections

Slide the tape-drive assembly most of the way into the tape-drive bay.

Connect the SAS signal cable and the power cable to the back of the tape drive.

Attention: Make sure that all the cables are positioned underneath the tape-drive assembly before

you insert the assembly in the tape-drive bay. Otherwise, the cables might be damaged.

Slide the tape-drive assembly the rest of the way into the tape-drive bay.

Push the latch to the closed (locked) position.

If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.

To install a USB hypervisor flash device, complete the following steps:

Lenovo System x3650 M4 Installation and Service Guide

power cables

drive signal