Lenovo System x3650 M4 Installation And Service Manual page 265

2.5-inch
simple-swap
hard disk drive
Release latch
Figure 166. 2.5-inch simple-swap hard disk drive removal
3.5 inch simple-swap
hard disk drive
Figure 167. 3.5-inch simple-swap hard disk drive removal
Step 4. Reinstall the drive bay filler panel that you removed earlier.
Step 5. If you are instructed to return the drive assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing a simple-swap hard disk drive
Use this information to install a simple-swap hard disk drive.
You must turn off the server before installing simple-swap drives in the server. Before you install a
simple-swap SATA hard disk drive, read the following information. For a list of supported hard disk drives,
see http://www.lenovo.com/ serverproven/.
• Locate the documentation that comes with the hard disk drive and follow those instructions in addition to
the instructions in this chapter.
• Make sure that you have all the cables and other equipment that are specified in the documentation that
comes with the drive.
• Select the bay in which you want to install the drive.
• Check the instructions that come with the drive to determine whether you have to set any switches or
jumpers on the drive. If you are installing a SATA device, be sure to set the SATA ID for that device.
• You can install up to six 3.5-inch simple-swap SATA hard disk drives in the server. Do not install hot-swap
drives into a simple-swap server model, it is not supported.
• You can install one 2.5-inch simple-swap SATA hard disk drives in bay 0 in the server. Do not install
hot-swap drives into a simple-swap server model, it is not supported.
Filler panel
Filler panel
.
Chapter 6 Removing and replacing components
253