Installing A Hot-Swap Ac Power Supply - Lenovo System x3650 M4 Installation And Service Manual

Machine type: 7915

Hide thumbs Also See for System x3650 M4:

Table of Contents

Figure 54. Network adapter installation

Press the adapter firmly until the pin, and retention brackets engage the adapter. Make sure the

adapter is securely seated on the connector on the system board.

Attention: Make sure the port connectors on the adapter are aligned properly with the chassis on

the rear of the server. An incorrectly seated adapter might cause damage to the system board

or the adapter.

Fasten the thumbscrew on the rear side of the chassis.

Step 10. Fasten the two captive screws on the network adapter.

Step 11. Reinstall the PCI riser-card assembly in PCI riser connector 2 if you have removed it previously (see

"Replacing a PCI riser-card assembly" on page 278).

If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on

Installing a hot-swap ac power supply

Use this information to install a hot-swap ac power supply.

The following notes describe the type of power supply that the server supports and other information that

you must consider when you install a power supply:

• Before you install an additional power supply or replace a power supply with one of a different wattage,

you may use the Power Configurator utility to determine current system power consumption. For more

information and to download the utility, go to http://www.ibm.com/systems/bladecenter/resources/

powerconfig.html.

• Before you install an additional power supply or replace a power supply with one of a different wattage,

go to Table 2 "Power supply configurations" on page 9 for detailed configurations.

Lenovo System x3650 M4 Installation and Service Guide

Captive screws

adapter connector