Lenovo System x3650 M4 Installation And Service Manual page 81

• When the server is in standby mode, both ports on the Emulex Dual Port 10GbE SFP+ Embedded VFA
III function at 100M connection speed with Wake on LAN feature.
The Emulex Dual Port 10GbE SFP+ Embedded VFA III is automatically disabled if one of the following
errors occurs:
• An error log indicates a temperature warning for the Ethernet adapter.
• All power supplies are removed or the server is disconnected from the power source.
To install the dual-port network adapter, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the cover (see "Removing the cover" on page 37).
Step 4. Remove the PCI riser-card assembly (if installed) from PCI riser connector 2 (see "Removing a PCI
riser-card assembly" on page 277).
Step 5. Remove the adapter filler panel on the rear of the chassis (if it has not been removed already).
Figure 53. Adapter filler panel removal
Step 6. Touch the static-protective package that contains the new adapter to any unpainted metal surface
on the server. Then, remove the adapter from the package.
Step 7. Align the adapter so that the port connectors on the adapter line up with the pin and thumbscrew
on the chassis; then, align the connector of the adapter with the adapter connector on the system
board.
Network adapter
filler panel
.
Chapter 2 Installing optional devices
69