Lenovo System x3650 M4 Installation And Service Manual page 345

Attention: Do not touch the connectors on the microprocessor and the microprocessor socket.
Step 7. Install the microprocessor on the microprocessor socket:
a. Touch the static-protective package that contains the new microprocessor to any unpainted
on the chassis or any unpainted metal surface on any other grounded rack component; then,
carefully remove the microprocessor from the package.
b. Release the sides of the cover and remove the cover from the installation tool. The
microprocessor is preinstalled on the installation tool.
Installation tool
Microprocessor
Figure 246. Installation tool cover removal
Note: Do not touch the microprocessor contacts. Contaminants on the microprocessor
contacts, such as oil from your skin, can cause connection failures between the contacts
and the socket.
c. Align the installation tool with the microprocessor socket. The installation tool rests flush on
the socket only if properly aligned.
Figure 247. Installation tool alignment
d. Install the microprocessor using the following instructions for your installation tool.
Cover
.
Chapter 6 Removing and replacing components
333