Updating The Server Configuration - Lenovo System x3650 M4 Installation And Service Manual

Figure 136. Front view
Ethernet1
(shared system
management ethernet) Ethernet2 Ethernet3 Ethernet4
System-management
(ethernet)(dedicated)
Figure 137. Rear view
You must turn off the server before you connect or disconnect cables.
See the documentation that comes with any external devices for additional cabling instructions. It might be
easier for you to route cables before you connect the devices to the server.
If the server comes with an installed operating system, see the documentation that comes with the operating
system for additional cabling instructions.

Updating the server configuration

Use this information to update the server configuration.
When you start the server for the first time after you add or remove a device, you might receive a message
that the configuration has changed. The Setup utility starts automatically so that you can save the new
configuration settings.
Some optional devices have device drivers that you must install. For information about installing device
drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a hard disk drive, see the
documentation that comes with the RAID adapter for information about reconfiguring the disk arrays.
If you have installed a USB hypervisor memory key on the SAS riser-card, see the user's guide that comes
with the hypervisor memory key. Hypervisor enables guest operating systems to function on the server.
For information about configuring the integrated Gigabit Ethernet controller, see "Configuring the Ethernet
controller" on page 155.
140
Lenovo System x3650 M4 Installation and Service Guide
10G ethernet
(with optional
10G ethernet card)
Video Serial USB3 USB4
Power supply 2
USB5 USB6 NMI Power supply 1
button