Flat Field Correction Category; Flat Field Correction Feature Description - Teledyne m640 User Manual

Flat Field Correction Category

The Nano Flat Field Correction controls, as shown by CamExpert, groups parameters used to
correct sensor or lens luminance differences. Currently these controls are available on the Nano XL
models M/C 5100 and M/C 4090.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications.

Flat Field Correction Feature Description

The following table describes these features along with their view attribute and device framework
version. For each feature the device version may differ for each camera sensor available. Such
differences will be clearly indicated for any applicable feature.
As Genie Nano capabilities evolve the device firmware version will increase, therefore identifying
the supported function package. New features for a major device version release will be indicated
by green text for easy identification.
The description column will indicate which feature is a member of the Teledyne DALSA Features
Naming Convention (denoted by DFNC), versus the GenICam Standard Features Naming
Convention (SFNC not shown).
Operational Reference • 113
Nano Series GigE Vision Camera