Teledyne m640 User Manual page 175

Display Name
Device Link Selector
Device Link Throughput
Limit
Device Link Throughput
Limit
Stream Channel Selector
Device Link Speed
PacketSize
Interpacket Delay
Packet Resend Buffer Size
IP Configuration Status
None
PersistentIP
DHCP
LLA
ForceIP
Current IP Address
Current Subnet Mask
Current Default Gateway
Current IP set in LLA
Current IP set in DHCP
Current IP set in
PersistentIP
Primary Application IP
Address
Nano Series GigE Vision Camera
Feature & Values
DeviceLinkSelector
DeviceLinkThroughputLimitMode
DeviceLinkThroughputLimit
GevStreamChannelSelector
GevLinkSpeed
GevSCPSPacketSize
GevSCPD
devicePacketResendBufferSize
GevIPConfigurationStatus
GevCurrentIPAddress
GevCurrentSubnetMask
GevCurrentDefaultGateway
GevCurrentIPConfigurationLLA
GevCurrentIPConfigurationDHCP
GevCurrentIPConfigurationPersistentIP
GevPrimaryApplicationIPAddress
Description
Selects which Link of the device to control
When disabled, lower level TL specific
features are expected to control the
throughput. When enabled,
DeviceLinkThroughputLimit controls the
overall throughput.
Limits the maximum bandwidth of the
data that will be streamed out by the
device.
Selects the stream channel to control.
Indicates the transmission speed
negotiated by the given network interface.
Specifies the stream packet size in bytes
to send on this channel.
Indicates the delay (in µs) to insert
between each packet for this stream
channel. Note that Interpacket delay
becomes a Read-Only value when the
feature "Device Link Throughput Limit" is
enable.
Indicates the amount of memory to
reserve in Mbytes for the packet resend
buffer. Changes in reserved memory
affects total memory available for
acquisition buffering.
Reports the current IP configuration
status. (RO)
None Device IP Configuration is not defined.
PersistentIP Device IP Address Configuration is set to
Persistent IP (static).
DHCP Device IP Address Configuration is set to
DHCP (Dynamic Host Configuration
Protocol). Network requires a DHCP
server.
LLA Device IP Address Configuration is set to
LLA (Link-Local Address). Also known as
Auto-IP. Used for unmanaged networks
including direct connections from a device
to a dedicated NIC.
ForceIP Device IP Address Configuration is set to
ForceIP. Used to force an IP address
change.
Reports the IP address for the given
network interface.
Reports the subnet mask of the given
interface.
Reports the default gateway IP address to
be used on the given network interface.
Controls whether the LLA (Link Local
Address) IP configuration scheme is
activated on the given network interface.
Controls whether the DHCP IP
configuration scheme (Dynamic Host
Configuration Protocol) is activated on the
given network interface.
Controls whether the PersistentIP
configuration scheme is activated on the
given network interface.
Returns the IP address of the device
hosting the primary application. (RO)
Device Version
& View
1.00
Expert
1.00
Guru
1.03
Guru
1.00
Expert
1.00
Expert
1.00
Expert
1.00
Expert
1.00
DFNC
Guru
1.00
Guru
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Guru
1.00
Guru
1.00
Guru
1.00
Guru
Operational Reference • 173