Teledyne m640 User Manual page 63

Display Name Feature & Values
Manufacturer Name DeviceVendorName
Family Name DeviceFamilyName
Model Name DeviceModelName
Device Version DeviceVersion
Manufacturer Part deviceManufacturerPartNumber
Number
Manufacturer Info DeviceManufacturerInfo
Firmware Version DeviceFirmwareVersion
Serial Number DeviceSerialNumber
MAC Address deviceMacAddress
Device User ID DeviceUserID
Device Built-In Self Test deviceBIST
Device Built-In Self Test deviceBISTStatus
Status
Passed
Last firmware update
failed
Unexpected Error
Sensor Initialization
Failure
Firmware Error
Device Built-In Self Test deviceBISTStatusAll
Status All
Device Reset DeviceReset
Device Temperature DeviceTemperatureSelector
Selector
Internal
MaxInternal
Nano Series GigE Vision Camera
Description
Displays the device vendor name.
Displays the device family name.
Displays the device model name.
Displays the device version. This tag will also
highlight if the firmware is a beta or custom
design. (RO)
Displays the device manufacturer part
number.
This feature provides extended manufacturer
information about the device. Genie Nano
cameras show which firmware design is
currently loaded.
Displays the currently loaded firmware version
number. Firmware files have a unique number
and have the .cbf file extension.
Displays the device's factory set serial
number.
Displays the unique MAC (Media Access
Control) address of the Device.
Feature to store a user-programmable
identifier of up to 15 characters. The default
factory setting is the camera serial number.
(RW)
Command to perform an internal test which
will determine the device status. (W)
Return the status of the device Built-In Self-
Test. Possible return values are device-
specific.
Passed No failure detected
FirmwareUpdateFailure Last firmware update operation failed.
Unexpected_Error Switched to recovery mode due to unexpected
software error.
SensorFailure There was an error initializing the sensor. The
camera may not be able to capture images.
(1.05)
FirmwareError Firmware encountered an error during
streaming.
(1.06)
Return the status of the device Built-In Self-
Test as a bitfield. The meaning for each bit is
device-specific. A value of 0 indicates no
error.
Bit-0=1:Firmware Update Failure
Bit-2=1:Unexpected Error
Resets the device to its power up state. (W)
Select the source where the temperature is
read.
Internal Value from FPGA and or PHY temperature.
MaxInternal Records the highest device temperature since
power up. Value is reset on power off.
Device
Version
& View
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
1.00
Expert
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
Operational Reference • 61