Teledyne m640 User Manual page 163

Events Overflow
Event Notification
Off
On
GigEVisionEvent
Event Statistic Selector
Invalid Frame Trigger
Image Lost
Packet Resend
Packet Resend Request
Dropped
Ethernet Pause Frame
Received
Event Statistic Count
Event Statistic Count
Reset
PTP Mode
Off
Automatic
Slave
PTP Status
Initializing
Faulty
Nano Series GigE Vision Camera
eventsOverflow
EventNotification
GigEVisionEvent
eventStatisticSelector
InvalidFrameTrigger
ImageLost
PacketResend
PacketResendRequestDropped
EthernetPauseFrameReceived
eventStatisticCount
eventStatisticCountReset
ptpMode
Automatic
ptpStatus
Initializing
Event sent on control channel when all previous
active events have been disabled because the
camera cannot send them fast enough, generating
in internal message overflow. Required events
must be re-enabled manually.
Enable Events for the event type selected by the
EventSelector feature.
Off The selected event is disabled.
On The selected event will generate a software event.
The selected event will generate a software event.
This entry is deprecated.
Using "On" is recommended.
Selects which Event statistic to display.
Counts the frame trigger occurring in an invalid
Trigger region.
Image is acquired but lost before it's been
transferred.
Counts the number of individual packets that are
resent.
Counts the number of packet resend requests
dropped. The camera queues the packet resend
requests until they are processed. There is a limit
to the number of requests that can be queued by
the camera. When a new request is received and
the queue is full, the request is dropped but this
statistic is still incremented.
Counts the number of Ethernet Pause Frame
received. Feature limited to 65536 events. See
also PAUSE Frame Support
Ethernet Packet size.
Display the count of the selected Event.
Reset the count of the selected Event.
Specifies the PTP (IEEE-1588: Precision Time
Protocol) operating mode as implemented by the
Genie Nano.
Off PTP is disabled on the device.
PTP is enabled on the device. The camera can
become a Master or Slave device. The Master
device is automatically determined as per IEEE-
1588.
Slave Device will operate in PTP slave-only mode.
Specifies dynamically the current PTP state of the
device. (ref: IEEE Std 1588-2008)
The port initializes its data sets, hardware, and
communication facilities. No port of the clock shall
place any PTP messages on its communication
path. If one port of a boundary clock is in the
INITIALIZING state, then all ports shall be in the
INITIALIZING state.
Faulty The fault state of the protocol. A port in this state
shall not place any PTP messages except for
management messages that are a required
response to another management message on its
communication path. In a boundary clock, no
activity on a faulty port shall affect the other ports
of the device. If fault activity on a port in this state
cannot be confined to the faulty port, then all
ports shall be in the FAULTY state.
for information on
Operational Reference • 161
1.00
Expert
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.03
Expert
DFNC
1.03
Expert
DFNC