Digital Projection HIGHlite Laser II 3D Series
Changing The Lens
The lens hood
There are two types of lens hood, short and long.
The short lens hood is used with the following lenses:
Throw ratios
Part number
0.77 : 1 fixed lens
110-808
1.16 : 1 fixed lens
110-809
1.45 - 1.74 : 1 zoom lens
110-803
1.74 - 2.17 : 1 zoom lens
112-878
2.17 - 2.90 : 1 zoom lens
113-852
2.90 - 4.34 : 1 zoom lens
110-806
The long lens hood must be used with the following long throw lens:
Throw ratios
Part number
4.34 - 6.76 : 1 zoom lens
110-807
Installation and Quick-Start Guide
CHANGING THE LENS
Projector with short lens hood fitted
Projector with long lens hood fitted
Notes
Before changing the lens,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the lens, avoid
using excessive force as this may
damage the equipment.
Take care to preserve the original
lens packaging and protective caps
for future use.
Do not use the short lens hood
with the 4.34 - 6.76 : 1 zoom lens.
The projector will not power on
without the lens and lens hood fitted.
Rev B December 2016
page 13