Setting Two-Line Dialing; Enabling And Configuring H.331 Broadcast Mode - PictureTel Concorde 4500 Administrator's Manual

Setting Two-Line Dialing

When a videoconferencing system is connected to some network
switching equipment, primarily European, this equipment cannot
answer both lines of an incoming video call simultaneously. To
adjust to this situation, you can use the Set Two-Line Dialing screen
to set your system to delayed dialing (the factory default setting).
The system then dials a two-line video call one number at a time, as
follows:
Dials the Þrst number
Waits until the connection is made (about 10 seconds)
Dials the second number
To change the dialing mode:
1. From the S et Network Configuration menu, choose Set Two-Line
Dialing .
You see these choices:
Simultaneous
Delayed [X]
An
[X]
2. Choose the desired setting.
An
[X]
Enabling and Configuring H.331 Broadcast Mode
H.331 broadcast mode is a feature that enables you to have a
videoconference in which one site transmits video and audio to
many sites. The receiving sites can see and hear video and audio
from the sending site (the broadcaster), but the broadcaster does not
receive any video or audio from the other sites. This is known as a
broadcast transmission Ñ in other words, a one-way transmission.
When the H.331 broadcast mode feature is enabled, your system can
communicate with a terminal or a multipoint bridge that supports
this feature. The sending site and the receiving sites must have the
H.331 broadcast mode enabled on their systems to participate in the
H.331 broadcast videoconference.
appears next to the current setting.
appears next to the setting you chose.
Using the Network ConÞguration Menus
2-25