Figure 2-2: Adapter Cable And Connection Panel For A V.35 Network Interface - PictureTel Concorde 4500 Administrator's Manual

CONNECTING AND CONFIGURING YOUR NETWORK
2-6
To connect your system to a V.35 network interface:
1. Connect the two network cables to the two M-34 connectors on the
V.35 adapter cables.
2. Plug the DC-37 connectors on the two adapter cables into the
CHAN connectors on the Communications board V.35 network
panel, as shown in Figure 2-2.
Take care when aligning the connectors.
Port 1 on the electronics module must interface with the lowest
numbered or lettered port on the network interface device.
V.35 DC-37 connector
PORT 2
CHAN
CTRL
A
DIAL
PORT 1
CHAN
CTRL
B
DIAL
Figure 2-2: Adapter Cable and Connection Panel
for a V.35 Network Interface
3. Tighten the screws on the connectors.
4. Connect the RS-366 cables to the DIAL connectors next to the
CHAN connectors.
M-34 connector