Setting Control Port B - PictureTel Concorde 4500 Administrator's Manual

Setting Control
Port B
F Y I
Table 6-2: Control Port A Type Settings (Continued)
Setting
Control Protocol
(default)
To change the Control Port A settings:
1. From the Configuration menu, choose Set Data Port Configuration .
The Set Data Port ConÞguration menu appears.
2. Choose Set Control Port A .
3. Choose a selection from the menu.
A selection menu for
Rate appears
4. Choose a new setting or enter a baud rate.
The Set Control Port A ConÞguration screen appears with the
new setting or rate.
You can use Control Port B to pass data, for example, between your
PC and a PC at another videoconferencing site. In addition, you can
use the system network manager program to send and receive
control protocol messages through Control Port B.
Table 6-3 lists the options when you choose
the Set Data Port ConÞguration menu.
The conÞguration of Control Port B determines the list of
F.Y.I.
options on the screen.
Used to send and receive control protocol
messages, which can be status and/or
diagnostic information from a far-end site
or from a near-end device, such as a PC.
or
Type Parity
.

Setting Control Port B

Definition
or a box to enter a new
t
Set Control Por
Baud
from
B
6-3